NO WATER PRODUCED. MOISTURE IS VENTED AWAY. EVEN UPWARDS.
Ideal for Flood Drying, Building Maintenance & Storage.
35 litre Desiccant Dehumidifier 220V / 50Hz.
Free Standing or Installed.
Industrial dehumidifier DH2500 steel construction with tough epoxy paint finish.
Very small for its 45 litre capacity. Will dry 24/7 and dry even down to -20°C/-4°F. Can work up to 40°C/104°F. Perfect for any climate.
Steel Inside & Out.
Tough Enough Even for Hiring or Restoration.
Can be carried by one person and transported easily with the carrying handles.
Self regulating energy usage that adapts to air pressure differences using always the right amount of power to dry effectively.
3 Hole Dehumidifier.
Input process air is dust filtered & dried. Input air can be ducted in & out with a 125mm / 5″ duct. Wet air exhaust is 80mm / 3″ duct.
Thus, Ecor Pro’s research shows that the DH2500 will be four to seven times faster at drying buildings at low temperatures than a traditional compressor dehumidifiers.
- EPHUM220 Humidistat for DH2500, DH3500, EPD150, EPD200 £129.99
- Flexible Industrial Ducting 80mm / 3" Diameter Length 3m / 9' £99.99
- Flexible Industrial Ducting 80mm / 3" Diameter Length 6m / 18' £139.99
- Flexible Industrial Ducting 125mm / 5" Diameter Length 3m / 9' £99.99
- Flexible Industrial Ducting 125mm / 5" Diameter Length 6m / 18' £139.99
- FILTERDH Filter Three Pack for DH25XX, DH35XX, EPD150, EPD200 £29.99
Highly Compact – Small 35 Litre dehumidifier in the market.
Dust Filter – Simple reticulated dust filter in metal frame. Shakened clean or easily replaced. Prevent dust particles entering the unit and impeding performance.
Easy Repair – Easy to remove cover giving access to replace cord sets or warn parts via qualified persons. Lifetime of the DH2500 dehumidifier prolonged. Cord sets can be replaced in around 20 minutes.
On Four Feet – Anti scratch plastic feet.
Carrying Handle – Easy to carry by one person. Removable handle for when the product is being installed. Removable handles protect the dehumidifier duct flanges when in transit.
Humidistat Connection – There is no integral humidistat but one can be added very simply. A military standard connector is on the front of the unit. To add this use the remote humidistat EPHUM220. This will turn the dehumidifier on an off automatically.
Duct Air-In & Out – The dehumidifier has all ducts fitted with flanges to allow ducting to be added with 125mm / 5″ hard or flexible ducting.
Wet Air Exhaust – The DH25XX has one internal fan compared to two in the DH35XX. Both do not produce water. The moisture is vented away allowing it to work in colder temperatures. Slight negative pressure The moisture is purged from the system by 15% of the process air so will dry with slight negative pressure.
“Three Hole System” – One inlet and two outlets. With slight duct configuration the hole system can be used as a four hole industrial dehumidifier but needs accurate duct flow measurement. DH35XX an easier alternative, if concerned.