NO WATER PRODUCED. MOISTURE IS VENTED AWAY. EVEN UPWARDS.
Ideal Flood Or Home Dryer. Restoration Safe.
74 Pint Desiccant Dehumidifier 110V / 60Hz.
Equivalent to a 150 Pint Compressor Dehumidifier @65°F.
Free Standing or Installed.
Industrial dehumidifier EPD150 steel construction with tough epoxy paint finish.
Very small for its 74 pint capacity. Will dry 247 and dry even down to -20°C/-4°F. Can work up to 40°C/104°F.
Steel Inside & Out
Tough Enough Even for Hiring or Restoration
Can be carried by one person and transported easily with the carrying handles.
Self regulating energy usage that adapts to air pressure differences using always the right amount of power to dry effectively
3 Hole Dehumidifier
Input process air is dust filtered & dried. Input air can be ducted in & out with a 125mm / 5″ duct. Wet air exhaust is 80mm / 3″ duct
Thus, Ecor Pro’s research shows that the EPD150 will be four to seven times faster at drying buildings at low temperatures than a traditional compressor dehumidifiers
- Flexible Industrial Ducting 80mm / 3" Diameter Length 3m / 9' £99.99
- Flexible Industrial Ducting 80mm / 3" Diameter Length 6m / 18' £139.99
- Flexible Industrial Ducting 125mm / 5" Diameter Length 3m / 9' £99.99
- Flexible Industrial Ducting 125mm / 5" Diameter Length 6m / 18' £139.99
- FILTERDH Filter Three Pack for DH25XX, DH35XX, EPD150, EPD200 £29.99
- EPHUM110 Humidistat for DH2511, DH3511, EPD150, EPD200 £129.99
Highly Compact – Small 74 pint dehumidifier in the market.
Dust Filter – The desiccant industrial dehumidifier benefits from a simple reticulated dust filter in metal frame that can be shaken clean or easily replaced to prevent dust particles entering the unit and impeding performance.
Easy Repair – Maintenance and eventual repair have been thought through with an easy to remove cover that gives easy access to replace cord sets or warn parts by a qualified persons quickly. Prolonging the lifetime of the EPD-150 dehumidifier. Cord sets can be replaced in around 20 minutes
On Four Feet – Anti scratch plastic feet.
Carrying Handle – Easy to carry by one person. Hence, the handles also protect the dehumidifier duct flanges if in transit.
Humidistat Connection – There is no integral humidistat but one can be added very simply. A military standard connector is on the front of the unit. To add this use the remote humidistat EPHUM220. This will turn the dehumidifier on an off automatically.
Duct Air-In & Out – The dehumidifier has all ducts fitted with flanges to allow ducting to be added with 125mm / 5″ hard or flexible ducting.
Perfect for any climate.
Wet Air Exhaust – Hence, EPD-150 has one internal fan compared to two in the EPD200. Both do not produce water. Furthermore, moisture is vented away, thus works in colder temperatures. Moisture is purged from the system by 15% of the process air – dries with slight negative pressure.
“Three Hole System” – One inlet and two outlets. Hole system can be used as a four hole industrial dehumidifier via duct configuration. Needs accurate duct flow measurement. Should this is a concern, the EPD200 is an easier alternative.