DH2500 Deshumidificador de Desecante DryFan 35L

Suministro de 220V 50 Hz que se puede hacer funcionar con un convertidor de 12V DC-220V AC o con transformadores de 110V a 220V, restablecimiento automático de la energía en caso de interrupción del suministro de energía. Deshumidificador comercial de desecante con tecnología de "3 agujeros"; extracción de agua 35 litros máximo. Rango de funcionamiento desde -20°C hasta 40°C de temperatura ambiente máxima para aplicaciones de secado continuo, con una capacidad de volumen de aire de 380 m3/hr (380 m3/hr - Proceso / 75m3/hr - flujo de aire de salida). Funcionamiento muy eficiente y silencioso del ventilador y, sin embargo, bajo consumo de energía en uso para una gran capacidad de extracción de humedad. 56dB Aire de proceso en 125mm - Aire de proceso en salida 125mm - Aire de escape 80mm

SKU: DH2500 Categorías: Deshumidificadores EU, Deshumidificadores de almacenamiento , Deshumidificadores de Etiquetas: , Restauración
instalar deshumidificadores deshumidificadores de Ecor Pro
deshumidificador descargar manual de usuario deshumidificadores por Ecor Pro
comparar nuestros productos deshumidificadores por Ecor Pro

Positive or Negative Focus Flood Drying

Tent can not be sealed (3-hole drying). More effective to seal the tent using a 4-hole system
Positive Pressure Outside

Positive Pressure Splitting Dry Airflow

Negative Pressure Inside

Positive Pressure Splitting Dry Airflow 2

How to set up a drying tent

NO WATER PRODUCED. MOISTURE IS VENTED AWAY. EVEN UPWARDS.

Ideal for Flood Drying, Building Maintenance & Storage.

35 litre Desiccant Dehumidifier 220V / 50Hz.

Libre o instalado.

Industrial dehumidifier DH2500 steel construction with tough epoxy paint finish.Very small for its 45 litre capacity. Will dry 24/7 and dry even down to -20°C/-4°F. Can work up to 40°C/104°F.

Steel Inside & Out.Tough Enough Even for Hiring or Restoration.

Can be carried by one person and transported easily with the carrying handles.Self regulating energy usage that adapts to air pressure differences using always the right amount of power to dry effectively.

3 Hole Dehumidifier.

Input process air is dust filtered & dried. Input air can be ducted in & out with a 125mm / 5″ duct. Wet air exhaust is 80mm / 3″ duct.

Thus, Ecor Pro’s research shows that the DH2500 will be four to seven times faster at drying buildings at low temperatures than a traditional compressor dehumidifiers.

Partes asociadas

Explicación de las características

Highly Compact – Small 35 Litre dehumidifier in the market.

 
Dust Filter – Simple reticulated dust filter in metal frame. Shakened clean or easily replaced. Prevent dust particles entering the unit and impeding performance.
 
Easy Repair – Easy to remove cover giving access to replace cord sets or warn parts via qualified persons. Lifetime of the DH2500 dehumidifier prolonged. Cord sets can be replaced in around 20 minutes.
 
En Cuatro Pies - Pies de plástico anti arañazos.
 
Carrying Handle – Easy to carry by one person. Removable handle for when the product is being installed. Removable handles protect the dehumidifier duct flanges when in transit.
 
Humidistat Connection – There is no integral humidistat but one can be added very simply. A military standard connector is on the front of the unit.  To add this use the remote humidistat EPHUM220.  This will turn the dehumidifier on an off automatically.

Perfect for any climate.

Conducto de entrada y salida de aire - El deshumidificador tiene todos los conductos equipados con bridas para permitir que se añadan conductos con 125 mm / 5″ conductos duros o flexibles.

 
Wet Air Exhaust – The DH25XX  has one internal fan compared to two in the DH35XX. Both do not produce water. The moisture is vented away allowing it to work in colder temperatures. Slight negative pressure The moisture is purged from the system by 15% of the process air so will dry with slight negative pressure.
 
“Three Hole System” – One inlet and two outlets. With slight duct configuration the hole system can be used as a four hole industrial dehumidifier but needs accurate duct flow measurement. DH35XX an easier alternative, if concerned.
 
Power Supply – Thus, 220V supply 50Hz
 
Auto reset - Si hay una interrupción en el suministro de energía, el DH25XX continuará funcionando tan pronto como la energía haya sido devuelta. Perfecto en lugares donde hay una fuente de alimentación "sucia" que puede afectar a otros productos controlados electrónicamente.
 
Construcción de metal - Todo el metal con acabado de pintura epóxica tratado térmicamente para que sea resistente por dentro y por fuera. Diseñado para la longevidad.
 
5m / 15′ Cable de alimentación - no hay necesidad de unir los cables cuando se colocan, por ejemplo, en los espacios de descanso o en los lofts de la casa, por ejemplo.

Dehumidifier Installation

 

 

This is a 3-Hole dehumidifier meaning that there is one  fan inside.  Part of the dried process air is turned around, heated and used to purge the internal adsorption wheel of moisture that can be then vented away.

Moisture is "vented away".  No water is produced.  The moist air is vented to the outside or moved to another area that is ventilated. Most common installation.

Focussing the dry air gives faster drying times.  Example of "Positive Pressure" or forcing the dry air into areas it is needed
Recirculating the air to be dried gives a compound effect and gives faster drying.  This system is a "Negative Pressure" system.   Air has to replace the air that has been exhausted with the wet air.

15% of the air that is processed is expelled as wet air.  This air needs to be replaced.  Air from outside the room may be more humid.  This is averted with a larger model.

Having the machine in the area being dried and recirculating the air is the most efficient way of drying.  This system is "Negative Pressure. In a small enclosure, covered with plastic sheeting a frame is needed to ensure the tent maintains structure.  Rooms generally are not air tight so in larger rooms air can leak under doors etc

3-hole systems have one advantage over 4-Hole systems.  Around 60 Watts of energy will be retained in the process air flow with a 4-Hole system.  Normally this is not a problem (Same energy as an old home light bulb) but if it is a variable air valve may be added to balance the system with regen air. 

This assumes that the air from any variable inlet (variable in order to find balance of air flow) is colder than the air inside the room being dried.   Typical applications will include  buildings where heat generated by people is not covered fully by any air conditioning.

Peso 19.8 kg
Dimensiones 55 × 41 × 47 cm
(L x W x H)-(peso)

17.52" x 13.86" x 13.58" - 38.58lbs

Tecnología

Desecante

Extracto de Max

35L-74pt

Alimentación / enchufe / longitud del cable

900W, 220V, 50Hz, 3.5A / Sí BS/EU

Código de barras

8720648456060.

Color / Material

Negro amarillo / pintura epoyada de acero suave

Tamaño de los conductos

80mm (3.0")-125mm (5")

Piscina lista

No

Humidistato en el interior / Opción de humidistato

No / Sí

Asa de transporte / contenedor de agua / cable de alimentación Longitud

Sí / No / 5m

Velocidades del ventilador / sonido

1 / 56dB

Temperatura de funcionamiento

Menos 20?C a más 40?C

Reinicio de la salida de energía / Funciona desde el cubrecorriente DC-AC

Sí / Sí

Flujo de aire m3/hr

380 proceso / 75 escape

Reinicio del apagado

Trabaja desde el DC-AC Coverter

Tanque de agua

No

Material

Acero suave recubierto de expoxy

Aprobación

CE