EPD50 DryFan 50 Pt Desiccant Avfuktare

120V supply 60 Hz that can be run off a 12V DC-110V AC converters , auto power reset in case of power supply interruption. Smallest 25 pints desiccant dehumidifier in the market using “3-hole” technology. Operating range from -4°F up 104°F maximum room temperature for continuous drying applications, built-in humidistat container, and an optional remote humidistat can be added by way of using a simple plug-in low voltage jack plug. Very quiet fan operation at 44dB ideal for small spaces, with 85 CFM air volume capacity (73 CFM – exhaust / 12 CFM regen air flow). Compact, all metal construction inside and outside designed for longevity, flat carrying handle that can be extended to allow easy transport and mobility, and anti-scratch four plastic feet that can be swivelled out to make four anchor points so that the unit can be mounted with suitable screws to walls/ceilings or simply fastened down onto a surface. IP24 rating which means the unit can still operate even in more damp conditions. Reticulated and easy-to-clean dust filter in metal frame to prevent particulates from entering the unit and impeding performance. Auto reset function in case of power supply interruption Duct AIR-IN option is fitted with a metal duct flange on the filter grill to allow for an external 5″ duct to draw in the air from a more remote point, concentrate the most damp air into the unit to be dried if needed. An additional flange can be added to the AIR-OUT but is not provided with the unit. Exhaust duct made easy for permanent installation by plumber or a home DIY person using standard waste pipe 1.61 inch diameter fittings. Easy repair and maintenance, fast access to replace cord sets and worn-out parts Lightweight at 14.1 lbs. and comes with 15 ft. long power cord, minimizing the use of an extension cord when placed in an area where power outlet is limited 52dB Process air in 5″ – Process air out 5″ – Exhaust air 1.5″

installera avfuktare avfuktare av Ecor Pro
avfuktare ladda ner bruksanvisning avfuktare av Ecor Pro
jämföra våra produkter avfuktare av Ecor Pro

Positive or Negative Focus Flood Drying

Tent can not be sealed (3-hole drying). More effective to seal the tent using a 4-hole system
Positive Pressure Splitting Dry Airflow

Positive Pressure Splitting Dry Airflow 2

Floor Flood Positive Pressure Outside Tent

Negative Pressure

Simply put the dehumidifier in the room or tent and exhaust the wet air outside of the tent or outside of the room.

How to set up a drying tent

INGET VATTEN SOM PRODUCERAS. FUKT VENTILERAS BORT ÄVEN UPPÅT

Perfekt för översvämningstorkning, byggnadsunderhåll & förvaring

25 Pint Desiccant Dehumidifier 110V / 60Hz

Equivalent to a Compressor Dehumidifier of 50 Pints @ 68°F

Fristående eller installerat

Industrial dehumidifier EPD50 steel construction with tough epoxy paint finish.Very small for its 25 Pint capacity. Will dry 247 and dry even down to -20°C/-4°F. Can work up to 40°C/104°F.

Steel Inside & OutTough Enough Even for Hiring or Restoration

Can be carried by one person and transported easily with the carrying handles.Self regulating energy usage that adapts to air pressure differences using always the right amount of power to dry effectively

3 Hål avfuktare

Ingångsprocessluften dammfiltreras & torkas. Ingångsluften kan dras in & ut med en 125mm/ 5" kanal. Våtluftsavgassystem är 40mm / 1,5"-kanal

Ecor Pro’s research shows that the EPD50 will be four to seven times faster at drying buildings at low temperatures than a traditional compressor dehumidifiers

Delar associerade

Funktioner förklaras

Highly Compact – Small 25 Pint dehumidifier.

 
Dust Filter – This desiccant industrial dehumidifier benefits from a simple reticulated dust filter in a metal frame. Can be shaken clean or easily replaced to prevent dust particles entering the unit and impeding performance.
 
Easy Repair – Thus, maintenance and eventual repair have been thought through with an easy to remove cover that gives easy access to replace cord sets or warn parts by a qualified persons quickly. Prolonging the lifetime of the dehumidifier.
 
On Four Feet – Moreover, anti-scratch plastic feet that are design patented. Swivel out to provide anchor points for the dehumidifier.
 
Carrying Handle – In particular, easy to carry by one person. The handle can be removed when the product is being installed and replaced by a top lid without handle.
 
Humidistat Connection – Hence, an internal humidistat fitted and the possibility to put on an external humidistat. A jack plug connector is on the on the humidistat EPHUM24DF. Turns the dehumidifier on an off automatically. Furthermore, remotely if the dehumidifier is concealed or ducted in position.

Perfect for any climate

Duct Air-In & Out – Avfuktaren har alla kanaler försedda med flänsar som gör det möjligt att tillsätta kanaling med 125mm / 5" hård eller flexibel kanaling.

 
Wet Air Exhaust - Den har en intern fläkt. Fukten ventileras bort så att den kan arbeta i kallare temperaturer. Fukten rensas från systemet med 15% av processluften så torkar med lätt undertryck.
 
“Three Hole System” – The system is classed as a “three hole” system due to the one inlet and two outlets.
 
Observera att EPD50-avfuktarna har en processluftutloppsfläns. EPD30-modellerna gör det inte. Detta gör att torr luft kan överföras till ett utrymme.
 
Power Supply – Thus, 110V supply 60Hz
 
Automatisk återställning – Om strömförsörjningen bryts fortsätter avfuktaren att fungera så snart strömmen har återgått. Perfekt på platser där det finns en "smutsig" strömförsörjning som kan påverka andra elektroniskt styrda produkter.
 
All Metal Construction – Nevertheless, all metal with epoxy paint finish heat treated for strength inside & outside. Designed for longevity.
 
5m / 15′ Power Cord – Thus, no need to join cables when placed for instance in crawl spaces or lofts in the home for example.

Dehumidifier Installation

This is a 3-Hole dehumidifier meaning that there is one  fan inside.  It is a turbo fan like the other larger units in the range.  Part of the dried process air is turned around, heated and used to purge the internal adsorption wheel of moisture that can be then vented away.

Moisture is "vented away".  No water is produced.  The moist air is vented to the outside or moved to another area that is well ventilated. Most common installation. If the machine is in the room being dried the internal humidistat can be used to regulate humidity.  If ducted and outside the room or house being dried an external humidistat may be needed.

Perfect for crawl space areas or attic areas.  Close openings to the crawl space and the unit will regulate the humidity.  Use ducting to help spread the dry air around the crawl space area.
Recirculating the air to be dried gives a compound effect and gives faster drying.  This system is a "Negative Pressure" system.   Air has to replace the air that has been exhausted.  In a normal home air is actually being replaced  frequently typically 2.5 times per hour. No home is air tight.
The dehumidifier can be hidden from sight.  It can be placed in a cupboard, in a ceiling void or under a floor.  Dry air is taken from the room, dried and then clean, dry filtered air returned.  External humidistat may be needed in that instance.

To read more about garages see here

Perfect for crawl space areas or attic areas.  Close openings to the crawl space and the unit will regulate the humidity.  Use ducting to help spread the dry air around the crawl space area.

Strong Machine Even Used For Commercial Spot Drying

The model is build to a standard that professionals can also use.  The machine is perfect for focus drying.  Wet air is focussed to where the moisture is. Example of "Positive Pressure" or forcing the dry air into areas it is needed
Having the machine in the area being dried and recirculating the air is the most efficient way of drying.  This system is "Negative Pressure. In a small enclosure, covered with plastic sheeting a frame is needed to ensure the tent maintains structure.  Rooms generally are not air tight so in larger rooms air can leak under doors etc

Used on Boats as a "Carry on" or Installed

Perfect for ducting around the boat or for area such as cabin, engine room or forward locker.  Read More

Vikt 6,4 kg
Dimensioner 28 × 19 × 19 cm
(L x W x H)-(vikt)

11,81 × 7,87 × 7,87 tum – 14,11 lbs

Teknik

Torkmedel

Max utdrag

12L-25.4pt

Ström / Plugg / Sladdlängd

550W, 110V, 60Hz, 4.6A / Yes US

Streckkod

UPC 860001398021

Färg / Material

Vit / Mild stål Epoy Paint

Kanalstorlekar

40mm (1,5")-125mm (5")

Pool redo

Nej

Humidistat Inuti / Humidistat Alternativ

Ja / Ja

Bärhandtag / Vattenbehållare / Nätsladdlängd

Ja / Nej / 15"

Fläkthastigheter / Ljud

1 / 52dB

Fungerande temperatur

Minus 4? F till plus 104? F

Power Out Restart / Fungerar från DC-AC Coverter

Ja / Ja

Luftflöde CFM

85

Omstart av strömavbrott

Ja

Fungerar från DC-AC Coverter

Ja

Vattentank

Nej

Material

ETL, CETL